TP1, TP2, TP3: How to Copy Multi-Target Signals Without Wrecking Your Risk
By Nexus Copier Team ·
A typical Telegram signal does not have one target. It has TP1, TP2 and TP3, sometimes TP4. How your copier turns those three numbers into actual orders is the difference between a controlled 1% risk and an accidental 3% risk on the same signal.
Approach A: one order per take-profit
The copier opens three separate positions, each with the same stop loss and a different target. This is the most common default — and the most misunderstood. If each position is sized at your configured risk, you are not risking 1%. You are risking 3%, because all three share the same stop and will lose together.
Approach B: one position, partial closes
The copier opens a single position at your full intended risk and closes a percentage of it at each target — say 50% at TP1, 30% at TP2, the remainder at TP3. Total risk stays exactly what you configured, and you still scale out. This is what most professional risk management assumes.
The denominator trap in partial closes
There is a subtle bug worth knowing about. If you close 50% at TP1 and then 30% at TP2, is that 30% of the ORIGINAL position or 30% of what remains? Getting this wrong compounds: 30% of the remainder is only 15% of the original. Percentages should be expressed against the original volume so that your intended split is what actually happens.
Move to break-even after TP1
The most valuable single behaviour in multi-TP trading is moving the stop to entry once TP1 is hit. You have banked partial profit and the remaining runner now cannot lose. Almost every channel that says "move SL to entry" after the first target is describing this, and it should be automatic rather than something you rush to do manually.
When the broker limits how many positions you can hold
One-order-per-TP multiplies position count fast. Four channels posting four-target signals is sixteen positions from four ideas. If you are on a prop-firm account with a maximum position count, or a broker with a lot cap, partial-closing a single position is the only approach that scales.
How Nexus Copier handles it
Nexus supports both models and lets you choose how many TPs to copy. In partial-close mode you set the percentage taken at each target against the original volume, with optional automatic break-even after TP1. Percentages are validated against the broker's minimum lot step, so a partial close that would round to zero is handled rather than silently skipped.
Frequently asked questions
Does one order per TP multiply my risk?
Yes, if each order is sized at your full per-trade risk. Three positions sharing one stop loss lose three times as much as one. Either divide the size across the orders or use a single position with partial closes.
Should I close 50% at TP1 or let it all run to TP3?
That depends on the channel's actual hit rate per target. Many channels hit TP1 frequently and TP3 rarely, in which case scaling out captures far more of the edge than holding for the final target.
What does 'number of TPs to copy = 0' mean?
In most copiers it means take-profits are ignored entirely and the position is managed by stop loss and manual or trailing exits only. It is not the same as 'copy all TPs'.
What happens if a partial close is smaller than the minimum lot?
The broker rejects it. On a 0.01-lot position a 30% partial close is mathematically impossible, so a good copier either skips to a full close at the final target or warns you rather than failing silently.
#TakeProfit #TP1 #TP2 #TP3 #PartialClose #RiskManagement #ForexSignals #TomaDeGanancias #CierreParcial #GestionDelRiesgo #SenalesDeTrading #CopyTrading #Trading #Handelssignale #إدارة_المخاطر